Archives: QMG Products

QMG Product news and reviews

Mannok 100mm PIR Insulation

Mannok Therm Floor / MF insulation is a high performance, fibre free board, with a rigid thermoset insulation core and faced on both sides with a low emissivity composite foil facing.

The high compressive strength of Mannok Therm Floor / MF enables it to withstand the dead and imposed loads transmitted through the floor.

Mannok Therm Floor / MF is suitable for new build and refurbishments projects in both domestic and commercial build. With specific properties that optimise the performance of underfloor heating.

For suspended timber floors in particular, Mannok Therm Floor / MF reduces heat loss by an air infiltration method, making it the ideal solution for upgrading the thermal performance of existing floors.

Febmix Plasticiser 25L

Feb Febmix SW 25 Litre bulk deal Mortar Admix Admixture is an liquid plasticising air entraining admixture which forms extremely stable air bubbles in mortar mixes.

Replaces lime in the mix to provide an easy to work butter like consistency to the mortar and to prevent shrinkage, cracking and crazing during the setting process.

Febmix admix improves workability and freeze-thaw resistance in brick laying mortars, reduces the need for lime and soothes out variations between separate batches of sand and cement.

Feb mix Admix The Original is an admixture for brick and block laying mortars it significantly improves the workability of bricklaying and plastering mortars and significantly increases their resistance to freeze thaw cycles.

6″ Top Insert

The top insert is used in conjunction with the top plate and top clamp

It slides in the top end of your liner to ensure that a secure connection is made to the top clamp to stop the liner compressing

6″ Top Clamp

The basic cowl with mesh is designed to fit directly to your liner to ensure that no rain gets in to your liner, with the enhancement of a mesh casing to stop birds nesting in your liner

The cowl slides over the top of the liner and can be screwed into place with self tapping screws (not supplied) or alternatively can be cemented in to place at the top of the stack

6″ Basic Cowl With Mesh

The basic cowl with mesh is designed to fit directly to your liner to ensure that no rain gets in to your liner, with the enhancement of a mesh casing to stop birds nesting in your liner

The cowl slides over the top of the liner and can be screwed into place with self tapping screws (not supplied) or alternatively can be cemented in to place at the top of the stack

6″ Top Plate

The top plate is used at the top of your chimney stack in conjunction with the top clamp and top insert to hold the liner in place should you not have a chimney pot

The top plate is used to seal off your chimney stack, but has a pre-cut hole in the middle for the corresponding size of liner you require

The size of the top plate is 380x380mm

6″ Nose Cone

The nose cone is placed on the end of your liner to ensure that your liner doesn’t become damaged as it’s pulled down the stack

Attach the nose cone to the end of the liner that you are going to drop down your stack with draw string (not provided)

You can use gaffa tape to secure the connection of the cone to the liner